The Dominator 3.0” system is a no-compromise utilitarian, all-around suspension system. These 3.0″ King Shocks are longer-travel than our short arm systems with a long-arm specific tuning profile. The on-road ride is fantastic, the off-road ride will run circles around the Performance 2.5 and allow you to drive to the capability of the chassis without worrying that you’ve equipped the truck with enough shock to destroy the truck around the suspension. If it’s in the budget, this is the system we’d recommend for every Ram owner.
Fabricated Shock Towers and Rear Crossmember Gussets are Required to install, Axle Truss and Rear Shock Mounts are Highly Recommended.
CS-DD30SPKG-03-D-LA
- Carli Custom Tuned, LONG ARM specific Valving
- King 3.0" Remote Reservoir Shocks with 17-4 Stainless Shock Shafts
- Includes Front and Rear Shocks, Short Reservoir Mounts, & Limit Straps
- Fitment: 2003-2012 Ram 2500/3500 4x4 Diesel
- Only Compatible with Carli CS-DLRC-10-D Coils and Full Rear Springs
- 6.25" Shock Towers Required: CS-DFST625 (Not Included)
Add-Ons
Dodge 6.25in Tall Fabricated Shock Tower
CS-DFST625
- 3" Long Arm Kit Specific (for Short-Body 12" Shocks)
- 1/4" Cold Rolled Steel
- Slide Over Design
- Fully Gusseted and Braced
- 3/8" Stud Ring for extreme durability
- Black Powdercoat Finish
- Height: 6.25" from base to center of shock bolt.
Rear Shock Mount, Driver, 2003-12
CS-DRSMD
- Replaces weak Driver's side factory shock mount
- Necessity when running 3.0" rear shocks
- Combines 3/16" and 1/4" Steel for Strength
- WILL NOT FIT 2013-2500/3500
- WELD-ON Fabrication Part
Rear Shock Mount, Passenger, 2003-12
CS-DRSMP
- Replaces Passenger side factory shock mount
- Combines 3/16" and 1/4" Steel for Strength
- Good insurance when installing Driver's side
- WELD-ON Fabrication Part
Dominator Rear Gusset Kit
CS-D30GUSSET
- 1/4" Cold-Rolled Steel Gussets
- Replace and box section of spare tire crossmember removed for 3.0" shock clearance
Reservoir Rock Guard
CS-RRG
- Shock Reservoir Protection
- Stainless Hose Clamps
- Sold Individually
- Recommended for Rear shock leaning forward from the axle
- Fitment: Any 2.5", 3.0" or 3.5" Shock with 2.5" Reservoir
