Carli specific, blueprinted, Long-Travel King 2.5” shocks on all four corners. For the Long Arm system, we designed a second, off-road oriented 5-Port custom piston opposed to the 3-Ports in a short-arm Pintop 2.5” System. This piston and long arm tuning profile alters flow of the pressurized shock oil displacing a wider surface area of the tuning shims to increase bottom-out on sharp hits while providing a predictable, comfortable street ride.  We round off ALL our King shocks with shafts machined and polished from a solid piece of 17-4 Stainless. Unlike King’s standard shafts, there is no coating to wear off, weather is far less likely to hurt them and if there is a small chip, you can round the edges with emery cloth to ensure the seal housing isn’t damaged as they’re not brittle like the stock, hardened shafts. The shocks are finished with King oil good to -55* F. Note that all King shocks are built with a plated steel body. If subjected to inclement weather for extended periods, we recommend wrapping your shocks in 3M to provide a moisture barrier that’s replaceable.


  • Carli Custom Tuned, 5-Port Piston, LONG ARM specific Valving
  • King 2.5" Remote Reservoir Shocks with 17-4 Stainless Shock Shafts
  • Includes Front and Rear Shocks, Short Reservoir Mounts, & Limit Straps
  • Fitment: 2003-2012 Ram 2500/3500 4x4 Diesel
  • Only Compatible with Carli CS-DLRC-10-D Coils and Full Rear Springs
  • 6.25" Shock Towers Required: CS-DFST625 (Not Included)

Dodge 6.25in Tall Fabricated Shock Tower


  • 3" Long Arm Kit Specific (for Short-Body 12" Shocks)
  • 1/4" Cold Rolled Steel
  • Slide Over Design
  • Fully Gusseted and Braced
  • 3/8" Stud Ring for extreme durability
  • Black Powdercoat Finish
  • Height: 6.25" from base to center of shock bolt

Rear Shock Mount, Driver, 2003-12


  • Replaces weak Driver's side factory shock mount
  • Necessity when running 3.0" rear shocks
  • Combines 3/16" and 1/4" Steel for Strength
  • WILL NOT FIT 2013-2500/3500
  • WELD-ON Fabrication Part

Rear Shock Mount, Passenger, 2003-12


  • Replaces Passenger side factory shock mount
  • Combines 3/16" and 1/4" Steel for Strength
  • Good insurance when installing Driver's side
  • WELD-ON Fabrication Part

Reservoir Rock Guard


  • Shock Reservoir Protection
  • Stainless Hose Clamps
  • Sold Individually
  • Recommended for Rear shock leaning forward from the axle
  • Fitment: Any 2.5", 3.0" or 3.5" Shock with 2.5" Reservoir